[ForSale-Swap] Forsale X band lot of stuff and a little 2 gigs

[paulc]

Hello FOlks,

I am selling off all of my x band, some 2 gig stuff.  Between work, family,
and other activities there never seems to be enough time to dedicate to MW.

Some of the items I have multiples on on others just a single piece.

Idealy I would like to sell all of this to a single person or club that may
be in need of multiples and use them for club projects.


1) QTY 5   single  MA  Xband circulator 3 port with Wr-75 flanges

2) QTY 10    MA  Xband circulator 3 port with Wr-75 flanges, these are in
sets of 4 that are pinned and glued together.
		They can be dissasemmbled with care and the screw holes on the flanges
cleaned out and you end up with single units as descibed above.

3) QTY 2   Voltage controled vaiable microwave attenuators.  These are about
4" long with a WR-75 flange on each end. I used one with a brick feeding a
horn
		up on my roof to modulate the brick CW by using a 12 volt? PS switched at
a CW rate. ON the spec analyzer, Irecall greater than 25 db total
attenuation.  Kinf of a cool unit.  Through loss was less than 1 DB

4) QTY 2  Ku? band feed horns. Both with scalar rings. Waveguide input on 1
is rectangular , the other is round. 4 bolt flanges.

5) QTY 1   WR-75 to SMA adapter, match input tuning, directional coupler,
crystal detector.  This was used on the output of a TWTA

6) QTY 2.5 lbs or 1 cluster f......  better not but you get the idea SMA
hardline jumpers.  All sorts of odd shapes, Mostly male to male but some M
to F and 		F to F. Many are gold plated and some are stainless comnnectors.
Lengths vary from 2" to 1 '

7) QTY 2  WR 75 to EIA WR -90 flange Solid brass

8) QTY 2   These 2 models were removed from a workng 2 Ghz Motorola
Starpoint MW tranmitter.  They were the last thing before the antenna
redundancy relay.
		The units feel too heavy to be preamps.  SMA female in and out poweredby
12VDC

9) QTY 1    Removed from a workng 2 Ghz Motorola Starpoint MW tranmitter.
Shottky Mixer Model MRG6005a

10) QTY  2  3 section WR-75 notch filters no Idea where they are tuned

11) QTY 3   WR75 terminators.  These are the stepped type

12) QTY 1    Wr-75 Terminator Conical Style

13) QTY  3   WR-75 terminators without the internal load.  These can be
drilled and converted to WR-75 to SMA adapters

14) QTY  8    MW varactor diodes and holders.  These were used in a tuned
piece waveguide and then voltage was applied to change the capcitance of the
diode
		upsetting the phase shift in the waveguide causing phase modulation.

15)QTY   1   34 inch straight piece of WR-75 waveguide.  Possibly the base
for a slot antenna?


Thats all folks.

If someone make a reasonable offer I would like to sell all in one lot.
Plus shipping
I that does not happen,  I will post again and price individually

Thank you

PaulC

W1VLF














Paul A. Cianciolo
57 Huntington Drive
Harwinton CT 06791