[ForSale-Swap] FS: Old Radio & Test Eq. knobs

[marv_e_ads at juno.com]

************ Old Radio Knobs **************

These are all used, most have set screws, with nothing worse than minor
scuffs and smudges and  fit 1/4" shafts, unless noted.

Dakaware
    1-1/16" Knurled Knob  -- $3
     1-1/16" Knurled Knob w/ 1.5" skirt w/ white indicator line -- $5ea
     1-1/16" Knurled Knob w/ 2" skirt marked 0-10 -- $8
     1-5/8" Knurled Knob w/ 2-1/16" skirt & unfilled indicator line -- $8
     2-3/8" Knurled Knob w/ white vinyl pointer at skirt level -- $12 ea
     2-3/8" Knurled Knob w/ 3" skirt & unfilled indicator line -- $12
     2-1/16" skirt only -- $2

   Short (1-3/16")pointer knob w/ white indicator line  $1 ea
   Long (2") pointer knob w/ white indicator line  $1.50 

Harry Davies
   #1206  1-3/8" knobs  -- $4 ea
   Short (1-3/16")pointer knob unfilled indicator line -- Not sure if
this is Davies... There are a box of these --  2/$1 ea
  
Hewlett Packard (70's vintage)1-5/8" spinner knob w/ 3/8" bushing -- $10

Kenwood 5cm diameter knobs that look like they are from a Kenwood TS-830
(main tuning knob) or similar
    One that's been backfilled with shot to give it some heft -- $7 
    The plastic spinner version -- $15

Kurz-Kasch
   #308  1-1/8" knob  -- $4
   #308  1-1/8" knob w/ 1-3/4" brite metal skirt with 100 graduations and
tens indicated in black -- $8
   #309  1-5/8" knob w/ metal spinner and 2-1/4" black metal skirt with
100 graduations and tens indicated in white -- $12
   #309? (may not be KK) 1-5/8" knob w/ plastic spinner and 2-1/4" metal
skirt with 100 graduations and tens indicated -- $12
   
   #310  2-3/8" knob -- hub drilled out to 3/8" -- $8
   #310  2-3/8" knob w/metal spinner shaft -- $12 ea
   #311  2-1/16" skirted knob (some of the white lines are need refilling
on these) -- $8ea
   #380  1.5" skirted knob  -- $5 

       These look like what was on some '60's Hammarlund, Eico & Knight
Kit stuff
   #642  1.5" skirted knob  -- $5 
   #S-645 .75" skirted knob w/indicator line -- $5
   #647  1"    skirted knob w/indicator line -- $5 ea
   #653  1.5" skirted knob w/indicator line -- $5 ea
   

Millen?  (has a logo that looks like a "M" with an "I" superimposed at
the center) #309  3-1/2" Handwheel style knobs as seen on the SX-28, if I
recall correctly.
    These are all in need of minor plastic surgery -- two have chips out
the skirt where the set screw goes and one has had it's center drilled
through... perhaps, to make a concentric assembly??
$10 ea.

National HRT 2-1/16" diameter.  Black, trim rings somewhat tarnished --
$5 ea


National Type A Velvet Vernier dials-style 2 (marked 0-100 over 180
degrees) 3-3/8" or 4" diameter -- good condtion, $20 ea


... and if you are so disposed, I'm open to reasonable offers for all
     of them!

   There are also many knobs from 1960's Tektronix and Hewlett Packard
oscilloscopes, if anyone has any need, please inquire.
     

All of the above plus shipping, if necessary, naturally.

Contact:  Marv  WC6W   310 649 3111 (reasonable hours Pacific Time
please)
     or via:  Marv_E_Ads at Juno.com






*

________________________________________________________________
Sign Up for Juno Platinum Internet Access Today
Only $9.95 per month!
Visit www.juno.com