[ForSale-Swap] Wanted; Swap, buy, or trade

[Gary R]

Anyone have an Icom service manual available for the Icom F30 or F40 series
handhelds? Please email me directly if you have such a manual available. Thanks.

Gary.



Philip Atchley wrote:

> Hello
> I have a very nice and accurate signal generator, useful for either
> Boatanchor or solid state Radio alignment.  No manual, but here are the
> specifics as I have them.  I believe I saw a manual listed on the W7FG
> manual site.
>
> 1.  Brand & Model.  Clements Mfg Co, St Louis MO. (USA Made) Model SG-83C.
> 2.  Solid state with an AC power supply.
> 3.  Tunes 50kHz to 54MHz in 6 bands PLUS 1MHz Cal.  Stable after a short
> warm up. I typically turn it on 15 minutes before I want to use it.  (not
> hours like older units).
> 4.  Smooth easy analog tuning with large knob and dial.  Good dial
> resolution.
> 5.  Controls:  RF Adj, Band switch, Mod Adj, Modulation Int/Ext, Meter
> RF/Mod.
> 6.  7 step attenuator switches provide 0 to 100dB attenuation in 4dB steps.
> Using the RF Adj and output Meter, attenuation is infinitely adjustable.
> 7.  Steel case and internal shielded compartment provides excellent
> shielding. Weighs about 14 lbs.
> 8.  BNC output connector, BNC Ext Modulation connector
>
> This is a very nice generator, not at all like a lot of those Heath,  Leader
> and Eico "service shop" generators you see so often.
>
> Asking a Postal MO of $140 + UPS shipping for about 17lbs, to the Lower 48
> only.  NO TRADES.
>
> 73 de Phil  KO6BB
>
> ______________________________________________________________
> ForSale-Swap mailing list
>  FAQ: http://www.nethawk.com/1113/swap/swap.htm
> Home: http://mailman.qth.net/mailman/listinfo/forsale-swap
> Post: mailto:ForSale-Swap at mailman.qth.net