[ForSale-Swap] FS: Collins KWM-2, PM-2 and DX Eng. Voice Processor

[Eugene Rippen]

This KWM-2 is an CAA Excellent minus.  It would be an
excellent but for the tiny scrapes on the edge of the rim, 
and it does have the WATERS REJECTION TUNING
unit installed.  Otherwise it does not appear to have been
screwed up with "improvements" by self appointed Collins
engineering second guessers..  Works great!  $895.00,
including the Waters unit.  Waters units are selling for
$200 to $250.   28 pounds shipping.
http://www.foothill.net/~soundval/KWM2A-C1.jpg
http://www.foothill.net/~soundval/KWM2A-C2.jpg
http://www.foothill.net/~soundval/KWM2A-C3.jpg
http://www.foothill.net/~soundval/KWM2A-C4.jpg
http://www.foothill.net/~soundval/KWM2A-C5.jpg
http://www.foothill.net/~soundval/KWM2A-C6.jpg
http://www.foothill.net/~soundval/KWM2A-C7.jpg
http://www.foothill.net/~soundval/KWM2A-C8.jpg

PM-2  piggy-back power supply for KWM-2.  
Works fine. Looks good, with exception of a paint
scrape on the upper front corner.  The speaker is good.
22 pounds shipping.  $175.00.
http://www.foothill.net/~soundval/PM2-A.jpg
http://www.foothill.net/~soundval/PM2-B.jpg

I also have what appears to be a DX Engineering Voice
Processer for a KWM-2.  The label on it is totally faded
out.  These are a snap to install. No soldering.  All above
chassis.  Simply take two screws out of the top of the
HV cage, slip mounting flange under the top replace 
the two screws.  Pull one tube, insert adapter in socket,
insert tube in top of adapter.  That all there is to it.
$185 shipped 48 states.

Sell to anyone anywhere, but will only ship to 48 states
of USA.
Shipping charge will be the UPS ground rate for the
weight listed.  This covers packing expense, too.


Eugene Rippen, WB6SZS
105 Donnington, Auburn, CA 95603