[ForSale-Swap] FS: Power amplifier module from Atlas-180

[Phil Atchley]

Hello all
I have a Solid State power amplifier module from an Atlas-180 transceiver.
Rated 100W output the Xceiver covered 160-20M.  HOWEVER, I believe the same
module was used in other Atlas models such as the 110.  If so, the Amplifier
'should' cover the complete 1.8 to 30MHz Spectrum.

This has the low level drivers on the module so that it'll take a Sub-QRP
signal and bring it up to full output.  IF you wish to use it with a 5W QRP
rig you may need to remove the pre-driver transistors (GOOD homebrewer
project). It MAY possibly also be used to replace the driver/output tubes in
a rig such as a FT-101, TS-520 etc to provide solid state outputs.  (You're
on your own there).

I haven't checked the unit with RF, but the transistors tested good and it
isn't burnt so should be ok.  WITH a copy of the Atlas 180 manual for
schematics etc.

Asking $60.00 shipped to lower 48.  May consider a VERY GOOD handkey as
trade (though I'll need enough cash to ship the amplifier as I am on limited
income)

73 de Phil  KO6BB
Loving home provided for wayward Boatanchor Receivers
ko6bb at elite.net
Merced, Central California
37.18N 120.29W CM97sh



---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.325 / Virus Database: 182 - Release Date: 2/19/02