[ForSale-Swap] Looking for Autek QF-1A

[Phil Atchley]

Hello
I'm in need of an Autek QF-1A (must be an A model) audio filter.  Needs to
be in good working order.   (I gave my last one to a ham friend)

I will swap one of the following...

1.  A very nice Tenma 5 Amp regulated power supply model 72-280(5 Amp Int,
3.5A continious).  Good for powering HT's, QRP rigs etc.  I feel this is a
nicer supply than the R/S units.

2.  Heathkit Signal Generator, model SG-8.  Tunes 160kHz to 110MHz, has
internal/xternal modulation etc.  Works fine but case shows some age (would
paint nicely).

3.  LIKE NEW R/S boom headset.  These are the nice units with 2 padded, full
earpieces and the boom microphone.  I used them for F/D ONE season with a
Kenwood TS-440S/AT xceiver and they have been stored in a plastic bag since.
If I recall correctly, they cost me 49.95 and are no longer available.  Come
with the homebrew 8 pin adapter for Kenwood, wire your own for other radios
(OR I 'think' the Heil radio adapter cords will work).

I got 'burnt' on the last Autek QF-1A I swapped for (had a bad pot and mods)
so 'please' be sure your unit is good 8^)

Terms:  Each will pack their unit well and handle the shipping of their own
unit.

73 de Phil  KO6BB
DX begins at the Noise Floor!
ko6bb at elite.net
Merced, Central California
37.18N  120.29W CM97sh


---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.323 / Virus Database: 180 - Release Date: 2/9/02