[FlexNet] FlexNet32 + SoundModem problem ...

Mon, 13 May 2002 06:41:22 +0200

Hi Pavel,
you haven't write, which packet program you use. Some of them don't work
with with Flex32 under win9x. Also the driver for Baycom - there is no
Baycom driver for this version. Read careful the instalation manual of
Flexnet and packet program. Try use for example Paxon.
73! Michal

-----Original Message-----
From: Xavier Romain [mailto:[email protected]]
Sent: Saturday, May 11, 2002 11:32 PM
To: [email protected]
Subject: Re: [FlexNet] FlexNet32 + SoundModem problem ...

I've the same problem ... Did you have a solution ?

Thanks ...
73's.
----- Original Message -----
From: "Pavel Lajsner" <[email protected]>
To: <[email protected]>
Sent: Tuesday, January 08, 2002 18:20
Subject: [FlexNet] FlexNet32 + SoundModem problem ...

> Hi FlexNeteers,
>
> I've been trapped into following problem:
>
> two months ago I've successfully setup FlexNet 32 ver. 2.1 with latest
> SoundModem (dated 09/2001). Also older SoundModem (dated 08/2000) worked
OK.
> Both 1k2 and 9k6 installations worked well on my Dell CPiA Win2k
notebook.
> The only feature which I was not able to use was the PTT keying thourgh
COM
> port so I used VOX circuit instead (which is even better, the COM port
> remained free). The later versions of FlexNet (2.2, 2.3) suffered from
the
> problem mentioned below.
>
> Recently I tried to run the same configuration on other different
machines
> (Win98/Win2k - notebook/desktop) but following problem appeared in any
> configuration/version of both FlexNet/32 and SoundModem. Receive is OK.
> After first TX packet is sent out, FlexNet keeps sending some "packet"
> periodically (approx. every 1.5 s, not shown in Trace window though)
until
> FlexNet is shut down. The next packet is sent, next periodical sequence
with
> the same periodicity is started. If many (e.g. SABM) packets are sent,
the
> TX output remains almost all time active.
>
> Thus I started to play with configuration/versions on my Dell machine
I've
> ended up with the same trouble. Even worse, when trying to use older
> SoundModem (08/2000) it cannot be properly registered in Parameters
window
> of FlexNet32 (an exclamation mark is above the soundmodem record).
>
> I tried to delete all registry entries before, no help. I'm screwed up
and
> can't figure what's the issue here.
>
> Anyone experienced the same trouble?
>
> 73! Pavel [email protected]
>
> P.S. The soundmodemconfig's Diagnostics works properly in all cases/all
> machines/all versions.

_______________________________________________
FlexNet mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/flexnet