[FADCA] Clarification of TNC parameters DOS FPAC

[bud thompson]

John Green wrote:
> So, the bottom line is:
> - setkiss in the bat file sets the txd and other values during boot up.
> - tx xx will change the txd value if entered from the console.
> - the txd value in the cfg file should not be depended on to run the 
> switch. From what I can see it's only value is what is reported when tx 
> command is used the first time.
> As we have recommenced in the past, always reboot the pc when leaving a 
> site, especially if you have touched the keyboard.

> Some additional good news:
>    We now have 9k6 trunks from WPB to LaBelle.
>    The Fort Meyers folks are getting serious about putting in FPAC and 
> joining the network.
>
> 73  John

* * *
John - Thanks so much - yes, I'd pretty much come to the same conclusion, 
but had not quite figured out the absolute bottom line as to which TXd was 
really in charge!  For at least three years now, we have followed your lead 
and always rebooted just before leaving the site - We store the keyboard out 
of the way (where needed), reboot from the AC switch, and once the switch is 
running, we turn off the monitor - touching nothing else except the cabinet 
doors and locks!

Good to hear the additional good news - especially about getting Ft. Meyers 
closer to the network.

More later on the dual speak Mitrek.

73,

bud

>