[FADCA] New BBS program wants

Sat, 10 Jan 2004 11:48:10 -0500

could  it possibly add support for aea tncs in kiss mode and support for
kantronics  kp-3s  there are hundreds of these in use and to make the
program used wide spread it need to be  simple to install easy to run ,not
crash
and support the hardware that's all ready in use .
 I personally don't like to run another program to load my tnc's in my world
I was told to keep it simple as possible.
john----- Original Message -----
From: "bud thompson" <[email protected]>
To: <[email protected]>
Sent: Saturday, January 10, 2004 5:34 AM
Subject: Re: [FADCA] New BBS program wants

> Comments...
>
> The PacTOR Level mode is a function of the Data Controller, not the
> software.  At this time the SCS PTC Data controllers are the only ones
that
> use PacTOR 2 or 3.  Therefore to use PacTOR 2, 3 the series of SCS PTS
> controllers needs to be supported.
>
> Any dual port TNC (KAM, KPC9612, PTC, DRSI, etc,) should be supported for
> both ports to be used independently.(DRSI boards are ISA)
>
> bud N0IA
>
>
>
> _______________________________________________
> FADCA mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/fadca
>