[FADCA] Page using DSS dish for 2.4Ghz link

Fri, 15 Nov 2002 08:49:17 -0500

Yes, I sent a reply to it. LINUX FPAC will also afford us
that facility, in fact a LINUX box was how Brian got us
into the internet here in Tampa. Use of the tools and bits
and pieces of the communications stack in LINUX will alow
for that sort of operation, one person had asked about JNOS,
we have Brian's TNOS, and he is still alive and kicking and
doing upgrades to it. But to go from the FADCA network to
the wired world does not require the use of a BBS to do it,
just LINUX with all of the AX.25 and AXIP stuff.

You see IP over AX.25 is just treated as IP over any MAC layer,
in the AX.25 case just slower. FPAC is the networking part of
our AX.25 network, IP would be flowing inside that just as
it flows in ethernet packets, ATM packets, ppp packets or
whatever link layer protocol sets around it. Once it hits a
box where it is routed to another network it is up to that
networks drivers to encap it with the proper link layer protocol.

> -----Original Message-----
> From: russ [mailto:[email protected]]
> Sent: Friday, November 15, 2002 12:15 AM
> To: [email protected]
> Subject: Re: [FADCA] Page using DSS dish for 2.4Ghz link
> 
> 
> Hi, Chuck. I saw the note. I think I may have down loaded a 
> later version
> from the F6FBB site. kernal 2-2? Also I went to the dish site.
> 
> I reveived a note from another group that there had been a 
> denial of service
> attack on qth. Must have been something as the mail about dried up.
> Hopefully things are returning to normal
> 
> I sent a note the other day to you and to Bud regarding the continued
> discussion about the packet to internet and was wondering if 
> either saw it
> as I got little after sending it.
> 
> Russ
> 
> ----- Original Message -----
> From: <[email protected]>
> To: <[email protected]>
> Sent: Thursday, November 14, 2002 10:53 PM
> Subject: RE: [FADCA] Page using DSS dish for 2.4Ghz link
> 
> 
> >
> >
> > > -----Original Message-----
> > > From: n4xeo [mailto:[email protected]]
> > > Sent: Thursday, November 14, 2002 05:14 PM
> > > To: [email protected]
> > > Subject: Re: [FADCA] Page using DSS dish for 2.4Ghz link
> > >
> > >
> > > At 11:30 PM 11/13/2002 -0500, you wrote:
> > > >Here is a link to page using DSS dish for 2.4Ghz 
> antenna, note the
> > > >high tech wave guide
> >
> > Bill, thanks for that. I was seeing a bit of hand wringing over
> > the antennas and if you look at them, the DSS and MDS antennas
> > are easy to do.
> >
> > I have two DSS dishes I am going to build that simple monopole
> > feed in a can, but I am going to get me some copper pipe and
> > silver plate it so it will be a bit better at operation and not
> > rust up.
> >
> > By way, did anyone see that I found the floppy that has the
> > FPAC Linux setup on it?? I have heard from no one so do not know
> > if anyone wants a copy, if so tell me where to send the files.
> >
> > Or I can upload them somewhere for y'all to pull.
> >
> >
> > *****************************************************************
> > This e-mail and any files transmitted with it are 
> confidential and are
> > intended solely for the use of the individual or entity to 
> whom it is
> > addressed. If you have received this transmission in error, 
> please notify
> > the sender immediately and destroy any hard copies you may 
> have printed
> and
> > remove all copies of the e-mail from your hard drive. Opinions,
> conclusions
> > and other information in this message that do not relate to 
> the official
> > business of Utility Partners, Inc shall be understood as 
> neither given nor
> > endorsed by it.
> >
> > Visit us on the web at http://www.utilpart.com
> > *****************************************************************
> >
> >
> > _______________________________________________
> > FADCA mailing list
> > [email protected]
> > http://mailman.qth.net/mailman/listinfo/fadca
> >
> >
> 
> 
> _______________________________________________
> FADCA mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/fadca
> 

*****************************************************************
This e-mail and any files transmitted with it are confidential and are
intended solely for the use of the individual or entity to whom it is
addressed. If you have received this transmission in error, please notify
the sender immediately and destroy any hard copies you may have printed and
remove all copies of the e-mail from your hard drive. Opinions, conclusions
and other information in this message that do not relate to the official
business of Utility Partners, Inc shall be understood as neither given nor
endorsed by it.

Visit us on the web at http://www.utilpart.com 
*****************************************************************