[ETO_Alpha] Low Drive Mod - Alpha 76A (two tube)

[Robert Dorchuck W6VY]

Hope a few look at this - havent seen much activity on this reflector.
   
  I recently acquired a 76A and am going through it.  Looking at the 
  low drive mod instructions on the Alpha website it says that there should
  be 3 banks of 220 ohm resistors installed and just remove one to 
  complete the mod - no changes in the jumber connections.
   
  In looking at what I have I find 3 banks of 470 ohm resistors which
  is normal for the 3 tube models.
   
   
  This amp is all original and no mods that I can see except the 10 meter mod.
   
  Any ideas on how to proceed?
   
  Thanks all,
   
  Bob  W6VY