[Elecraft] K2 SSB low power
Michael Carter
Mike.Carter at unh.edu
Fri Oct 30 21:00:50 EDT 2026
Hi Luc,
Please measure the voltage in both TX and RX at pin 6 of U2 on the KSB2 board.
Please check the voltage at pin 15, U1 on the KSB2 board in TX mode.
The measured voltage at pin 5, U2 is the ALC Threshold setting. Unless the TX output power is very high, the voltage developed at VRF DET will not turn on Q1 in the ALC subcircuit. This is appropriate behavior for the tracking ALC system.
The voltage at pin 6, U2 sets the TX power level, and if it does not vary with the front panel POWER control, then it may indicate several possible causes of the fixed, low power output.
73,
Mike, K8CN
More information about the Elecraft
mailing list