[Elecraft] k2 on6cn
Michael Carter
Mike.Carter at unh.edu
Sun Oct 18 17:52:17 EDT 2026
Hi Carlos,
Thanks for checking the VFO output frequencies on each band.
In the K2, both low side (VFO below the desired frequency by the IF, 4915 kHz) and high side injection (VFO above the desired frequency by the IF) are used to keep the VFO tuning range to about 2 octaves (roughly 6 MHz to 24 MHz). Your measured frequencies by band do not conform to the proper IF offset in either direction, again indicating that the PLL is failing to lock.
Your additional observations on obtaining full output power on 80 meters, except at 4.2 MHz and that you get less output power on 15 meters, and that the power cannot be varied by the POWER control knob, are useful, but separate from the PLL problem. The fact that the VFO is putting out the wrong frequencies for a given band means that the bandpass filters will attenuate the transmit drive signal, and the lowpass filters after the PA stage may attenuate the output power further. Until we resolve the PLL issue, the other problems can be postponed.
I agree with Andrew - break the PLL at R30, inject a variable DC voltage via a current-limiting resistor into the VFO tuning circuit, and monitor the VFO output frequency as you vary the DC voltage. Be sure to keep the DC voltage between 0 V and +8 V at the R30 injection point. You should switch bands and repeat this experiment on each band to be sure that the band select relays K13, K14 and K15 are properly engaged on each band.
73,
Mike, K8CN
More information about the Elecraft
mailing list