[Elecraft] New K4 & K4/0 production software available (R40)
Wayne Burdick
n6kr at elecraft.com
Fri Nov 13 14:36:31 EST 2026
Software release R40 has been promoted to full production status. It
includes several new features, bug fixes, and new or enhanced remote
control commands. See full release notes below.
This release is recommended for all K4 and K4/0 owners. To ensure 100%
interoperation between transceivers and K4/0s (or remote control software
apps), you'll need to update both local and remote units.
73,
Wayne
N6KR
===========================================================
====================== R40.PRODUCTION =====================
===========================================================
November 11, 2026
------------
NEW FEATURES
------------
- TWO NEW WAYS TO DO BAND SELECTION:
Tapping the <GEN> (General Coverage) button replaces the normal BAND labels
with your first 12 non-ham/SWL frequency memories, showing VFO A values, as
well as text labels if applicable. The search starts at memory #001, so you
may wish to move your favorite SWL frequencies to low-numbered memories.
This is a much more convenient way to QSY to general-coverage frequencies
than scrolling through the <RCL> button list.
Similarly, tapping <MEM> displays the first 12 memories that are within ham
bands. Tapping <XVTR> still displays up to 12 transverter bands.
- NEW SSNR ICON (NR+): When SSNR (spectral subtraction noise reduction) is
in effect, the NR icon changes to NR+.
- NEW SSNR NOISE FLOOR RESET CONTROL: When SSNR is in effect, a <RESET>
button appears in the NR ADJ controls group. RESET may be tapped in the
absence of any signal to optimized the noise floor of the SSNR algorithm.
You can also perform a RESET using the NRS~; command, which can be assigned
to any programmable switch for quick access.
- PROGRAMMER'S REFERENCE AVAILABLE AT THE RADIO: To view the Programmer's
Reference, first tap the <?> (INFO) button to bring up the Operating
Manual, then tap the "gear" button. To search for commands in the
Programmer's Reference, tap the magnifying glass icon. This brings up the
on-screen keyboard.
- TRANSVERTERS NOW SUPPORTED IN REMOTE MODE. You can now recall a
transverter band on a remote server via a K4, K4/0, or software remote
client.
---------
BUG FIXES
---------
- BAND BUTTON TIMEOUT: The band button array now disappears automatically
after a 5-second period where none of the buttons are tapped, as was the
case in earlier versions.
- REMOTE CLIENT AUTO-CONNECT AT BOOT BUG FIXED: The RX Audio Latency
adjustment dialog now works correctly in this case.
- TRANSMIT CANCEL IMPROVEMENT: When any alert message is displayed, we
allow TUNE, XMIT, ATU TUNE, VOX, ANT, RXANT, and REC buttons to cancel
transmit and dismiss the alert window. This is especially important when
exiting internal or external fault conditions that occur while the K4 is in
transmit mode.
--------------
FOR DEVELOPERS
--------------
- NRS~; does the same thing as the SSNR RESET button (see above).
- MBn; command added where n = 0 is message bank 1, and n = 1 is message
bank 2.
- MB/; toggles the message bank.
- RE/; and TE/; toggle between FLAT and the last-used RX/TX EQ values.
- REF; and TEF; commands force RX/TX EQ to FLAT.
--
Elecraft, Inc.
More information about the Elecraft
mailing list