[Elecraft] K3 F6 Fault coupled with KPA1500 power input fault

[Dick Dievendorff]

I’d verify that the K3 menu item PWR SET is PER BAND and the KPA1500 menu item RADIO TYPE is K3.  Verify that the AUX cable connects K3 to amp.

Then on each band, put the amp in OPER, turn the K3 power way down, then key down and advance K3 power level until the amp power is right.  

The K3 should have two separate stored power levels for each band, one  each for amp in OPER and STBY.  My K3 changes power from 100 to about 25 watts when I change the KPA1500 from STBY to OPER.

It sounds like your K3 is putting out 100 watts with the amp in OPER.  That’s way too much.  20 to 30 is closer.  It’ll vary band to band.


73 de Dick, K6KR

> On Jan 6, 2025, at 14:56, RICK SCHMIEDT <schmiera at bellsouth.net> wrote:
> 
> Hey all,
> I have a 7000 serial number K3 that has performed flawlessly over the last 10 years.  But during the ARRL RTTY Roundup, my KPA1500 faulted with the message:
> Fault: Power input 102 Watts.  Then I noticed that there was a Fault 6 that flashed by on the K3 screen.  It now does this on all bands and into a dummy load.  It doesn’t seem to happen when the low power amp in the K3 is used (less than 13 Watts).
> 
> Without the amp in line, the K3 seems to work normally and the output power stays where it should.  I know this topic has been covered before, but I’m not finding a solution.  Can anyone point me in the right direction?  I have not contacted the Home Ship yet.
> 
> Thanks,
> Rick
> W4GE
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dick at elecraft.com