[Elecraft] K2 VFO knob

[W3FPR]

Glenn,

Be aware that there are two knobs that were used for the K2.  The older 
one has a smaller encoder shaft and if the encoder is a round one (with 
some green material on the body), you need toe knob to fit that encoder 
shaft).  OTOH, if the encoder is the newer type with a black cubical 
body, then you need the knob with the 1/4 inch shaft.
I do not know if Elecraft still has the older knob available, but the 
Yaesu knob will fit the older encoder shaft.

73,
Don W3FPR

On 12/14/2025 3:16 PM, Glenn Pritchard via Elecraft wrote:
> Hi everyone,
> I got an unfinished K2 and is complete but the VFO knob looks like it came
> from a Yaesu.
> Does anyone have an extra one or do I go directly to Elecraft?
>
>