[Elecraft] K3S help needed

[Fred Jensen]

Make sure VOX is turned on in the K3 and that it is set for straight key 
input ... i.e. internal keyer off.  If your K3 is properly configured, 
shorting the RCA Phono plug that goes into the Winkey should key the 
K3.  It is possible that you've got the Winkey configured for the second 
[KEY2] port, but I doubt that.

Years ago, the small fire in the corner of the chassis would lead us 
immediately to the area of the problem.  Not so much these days, but 
remember, "We always assume the worst. It rarely if ever is."

I don't have time now, but tomorrow, I'll look up the details and reply 
again.

73,

Fred ["Skip"] K6DGW
Sparks NV DM09dn
Washoe County

Carol Richards wrote on 3/20/2024 10:41 AM:
> Good day all….
>
> I recently acquired a nice K3S and am having all sorts of problems; not rig problems. I just installed a win-keyer so that I can use the K3S with N1MM. The installation went fine but now I can no longer key the rig and get output  Any thoughts or help?
>
> Thanks,
>
> Carol
> Sent from my iPhone
> ______________________________________________________________
> Elecraft mailing list
> Home:http://mailman.qth.net/mailman/listinfo/elecraft
> Help:http://mailman.qth.net/mmfaq.htm
> Post:mailto:Elecraft at mailman.qth.net
>
> This list hosted by:http://www.qsl.net
> Please help support this email list:http://www.qsl.net/donate.html
> Message delivered tok6dgwnv at gmail.com  



-- 
This email has been checked for viruses by AVG antivirus software.
www.avg.com