[Elecraft] K3 no transmitting

[Jorge Diez - CX6VM]

thanks Steve

Could you please point me to the assembly manual page to find it?

Mine is factory assembled, but I need to fix it here in my country, I need
to try

Thanks very much!

73,
Jorge
CX6VM/CW5W

El vie, 8 mar 2024 a las 13:32, Steve Cooke (<sjc.2 at hotmail.co.uk>)
escribió:

> Jorge ..... my K3 displayed the same fault sometime ago .Turned out to
> be D1 on the LPA ....a very fine hairline crack in the solder joint
> ...without Keith Trinity W6ER's advice in a previous reply to somebody
> else , I would never have found it .
>
>              It was only visible under a bright light ...and a
> magnifying glass .
>
>                          73 steve G1MPW.
>
>
> On 08/03/2024 13:58, Jorge Diez - CX6VM wrote:
> > hello
> >
> > My newer K3 is not TX anymore, on any mode, CW, SSB, FT8
> >
> >
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to cx6vm.jorge at gmail.com



-- 
73,
Jorge
CX6VM/CW5W