[Elecraft] K3 no transmitting

[ken.kj9b at gmail.com]

Make sure your K3 didn't get put in "Test" mode, shown by a flashing "TX"
toward the right side of the display.

73,
Ken, KJ9B

-----Original Message-----
From: elecraft-bounces at mailman.qth.net <elecraft-bounces at mailman.qth.net> On
Behalf Of Jorge Diez - CX6VM
Sent: Friday, March 8, 2024 8:59 AM
To: Howard K6IA Elecraft Support <k3support at elecraft.com>; Elecraft
Reflector <elecraft at mailman.qth.net>
Subject: [Elecraft] K3 no transmitting

hello

My newer K3 is not TX anymore, on any mode, CW, SSB, FT8

The reception is OK, I can listen without problem, all buttons works OK, I
cal also decode in FT8

But when I want to transmit, no RF output, on any mode

I do TUNE and the display show two lines ( _ _ ) and 0 W

We used it in ARRLDX CW and it was working properly. Then I connected to
remoterig for the remote station, I think we did some QSOs with no proble.
other day I wanted to use it and noticed that it was not transmitting

Any idea what could be wrong?

thanks in advance!!

--
73,
Jorge
CX6VM/CW5W
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to ken.kj9b at gmail.com