[Elecraft] K2 TUNE power reduction without ATU installed .

[Dave Van Wallaghen]

Steve,

I am not sure if this feature was always available on the KPA100 or when 
it was included (Don, W3FPR may know) but when the power is set above 
20W, pressing the TUNE button will reduce the power to 20W until the 
operation is terminated. If you hold and press both the TUNE and DISPLAY 
buttons, the KPA100 will output the power requested with the power 
control pot.

73,
Dave W8FGU


------ Original Message ------
>From "Steve Cooke" <sjc.2 at hotmail.co.uk>
To Elecraft at mailman.qth.net
Date 1/14/2024 4:10:12 AM
Subject [Elecraft] K2 TUNE power reduction without ATU installed .

>I've just recently bought a used K2 /100 for use at field days with my local club ( to save my own K2 from getting hammered too much ! ) . I'd like to use it with a remote ATU  . The output of the K2/100 is reduced to 20 W with an Elecraft ATU installed and the TUNE button pressed .... is it possible to fool the K2/100 into doing that when no ATU is installed ?
>
>The reason for trying to implement this is so that nobody has to remember to reduce the power level when changing bands and then trying to tune the ATU at 100 W .... at 4 a.m.  it is bound to happen sooner or later !
>
>73 steve G1MPW
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
>Message delivered to dave at w8fgu.com