[Elecraft] K3 RIT tuning rate

[Paul Kirley]

Dear OM Mark K1RX,

The tuning rate of the K3 RIT/XIT basically follows the rate of the main VFO.  Here are a few comments from one version of the operating manual:

VFOs and RIT/XIT
• RATE {21} selects 10 or 50 Hz VFO/RIT tuning. See VFO menu entries, pg. 57.
• FINE {21} selects 1-Hz steps. COARSE selects large steps (MAIN menu, VFO CRS).

FINE Select 1 Hz tuning for both VFOs and RIT/XIT offset

VFO CRS Per-mode Per-mode coarse tuning rate (hold COARSE and tune VFO A or B). Tap 1 to turn
rounding on/off. Also applies to the RIT/XIT tuning knob if CONFIG:VFO OFS  is set to ON, and both RIT and XIT are turned OFF.

73, Paul W8TM