[Elecraft] KX3 - CWT, no ALC in Data Mode

[Jim Brown]

On 10/28/2023 2:29 PM, John Overbaugh wrote:
> Messing around with PSK today and I'm stumped... I am sure I just switched
> a setting somewhere but I can't figure out where. When I am in DATA A mode
> for PSK, I see the CWT meter, not the ALC meter.

ALC shows only in TX mode. For digital modes, the manual says to set 
audio drive from the computer to the rig so that ALC reads 4 bars 
flashing 5 when transmitting. Digital modes should use the LINE Input. 
The correct audio drive setting is a combination of computer output gain 
and Line Input gain. When in Digital modes, the Mic Gain knob becomes 
Line Input gain. In general, computer output should set at least 6 dB 
below 100%.

73, Jim K9YC