[Elecraft] Kpod not Working on K3

[Ed Parish]

Have you connected both the RJ45 data cable and a separate power cable?

On Wed, Nov 15, 2023, 05:35 <semaos at semaos.plus.com> wrote:

> Hi All, I have taken my Kpod from my K4 and put it on my K3. (I assume it
> works for both rigs).
>
> The K3 has had the Mod completed as per the Kpod manual with a 6.8 Ohm, 1/8
> W Leaded Resistor  as per pages 16-18 of the Kpod manual.
>
> Problems.
>
> 1.      Kpod does not power up with the Data cable between K3 & Kpod
> connected (No leds lit up at all.
> 2.      When I power Kpod with a 12v source the On led shows as does D1 -
> D3
> when switched with the rocker switch.
> 3.      The large tuning knob on the Kpod does not function in any way.
>
>
>
> I have tested the Data cable with a network tester it is wired correctly
> 2-6
> pins only and they show satisfactory on the tester.
>
> I have tried programming Macros and saved to K3 accordingly but the Kpod
> doesn't activate any of them.
>
>
>
> Anyone have any ideas of possible problems that a dummy can fix or try at
> home please?
>
>
>
> TIA
>
> Chris G0TZZ
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to k1ep.list at gmail.com
>