[Elecraft] K3S Split Operation

[Bob McGraw]

SPLIT operation is easily accomplished with a single receiver K3S.  Five 
easy steps follows:

1.  Select the band, frequency and mode of your choice as seen on VFO A. 
   (that's the big knob)

2.  Press and release A > B button.  This sets VFO A and VFO B to the 
same band, frequency and mode.

3.  Press and hold A > B.  Upon release of A > B button one is now in 
the SPLIT mode.  You will observe the word  "SPLIT" just above the VFO B 
frequency (right side)  and TX  above the letter B for VFO B .

4.  Adjust VFO B for the desired TX frequency.  (use the small knob)

5.   VFO A is the receive frequency.

That's it.

73

Bob, K4TAX


On 11/6/2023 2:36 PM, elecraft-request at mailman.qth.net wrote:
> Message: 8
> Date: Sun, 5 Nov 2023 21:12:15 -0500
> From: Richard<FlatHat at comcast.net>
> To: Elecraft Reflector<elecraft at mailman.qth.net>
> Subject: [Elecraft] K3S Split Operation
> Message-ID:<A6148A63-C886-4EAB-82E3-7A577D7F62FD at comcast.net>
> Content-Type: text/plain;	charset=utf-8
>
> I am having trouble understanding both the manual and N6FN?s Mini-manual when it comes to Split operation. I follow the ?directions? over and over but nothing happens.
>
> Does the fact that my K3S does not have a sub receiver mean that I can?t work split?
>
> If I?m wrong about that I would really appreciate a step-by-step How-To lesson in working split.
>
> Thanks.
>
> Cheers,
> Richard Kunc
> W4KBX
>
> -
>