[Elecraft] K2/10 problem

[Allan Forster]

Hi,
I found that the actual power out did not match my setting, eg. I set 10 watts but power meter reads 14 Watts.
Simple to calibrate the auto ATU or so I thought. While adjusting the 2 pots on the ATU the rig suddenly powered down.  When I switched it back on the RX was not working, I followed the alignment procedure and it seems that the BFO is dead. Ie. In CAL FIL the BFO reading is all zeroes 
Any ideas?

Regards
Allan G4NNJ