[Elecraft] K3 For Sale (loaded)
bemeier at bellsouth.net
bemeier at bellsouth.net
Mon Jul 31 11:13:35 EDT 2023
For Sale
Original owner / non-smoking environment
K3 s/n 1193 was just replaced with K4D # 1285
Includes:
* KPA3 - 100w internal amp
* KIO3 (Remote I/O rev C) Serial CAT communications, digital I/O
control, audio I/O for use with sound cards, dual speaker and headphone
jacks, Aux connector
* KXV3 RF I/O, RX antenna, XVTR connections, IF out
* KAT3 ATU, AUX antenna input
* KRX3 Sub Receiver (able to fully use Diversity RX)
* KSYN3A (K3S) upgraded synthesizers in both main and sub
* Roofing Filters
* Main: 2.7khz, 400hz, 250hz
* Sub: 2.7khz, 400hz
* The following modifications / enhancements have also been installed
* Front panel Microphone Circuit Modification
* KI03 rev C upgrade (see above) K3IOBUFFKT
* 12VDC OUT current mod KPA3 12V Sense Mod
* K3 VFO Tuning Noise Reduction
* IF Output Buffer Gain Modification
* DSP upgrade
* Audio Output Chip Protection Mod K3 AF Output Mod Kit
* AF Stage Upgrade Line Out and Speaker Amp
* CW Keying rise time mod CWRTMDKT
* KRX3 Subout connector not installed / not needed but info and
parts supplied
* KPA3 Power Connector Replacement - Gold Pin mod
* All K3 and Option manuals as well as modification documentation
* (4) Spare set of knobs for AF gain / RF gain
* Spare B VFO tuning knob
* Spare SO-239 with attached plug (plugs into KAT3)
* Spare KI03 Main Rev C with (1) KI03 Remote Module rev B and (1) KI03
Remote Module rev XD (all working, just removed due to upgrade.
OTHER:
* Small top cover scratche by middle rear screw about ¼ long.
* Slight crack in VFO B knob repaired by Elecraft when in California
for Gold Pin mod. (does not impact operation)
* NOTE: A spare knob will be supplied (also slight crack and also
repaired by Elecraft)
* Latest revision firmware installed (MCU = 5.67, FPF = 1.26, DSP1 =
2.88, DSP2 = 2.88)
* Pictures available on request
Asking $2500.00 - - Includes insured UPS ground shipping to CONUS
destinations. ($2400.00 if shipping not required)
73,
Bruce N1LN
More information about the Elecraft
mailing list