[Elecraft] K3S - High SWR on 6 Meters

[Mike Fatchett W0MU]

What is the 6m antenna, how far away is it from the xmitter? Sounds like 
an issue with a balun or matching overheating with the stress of FT8?

I would hook the K3 up directly to the 6m antenna or the dummy load.  
Something is certainly acting odd.

W0MU

On 6/13/2022 2:07 PM, N4ST wrote:
> So, received a new KLPA3A & KPA3A from Elecraft in exchange for my old ones
> plus $$.
> Installed the new KLPA3A & KPA3A and passed LP and HP TX Calibration.
> My 6M beam measures 1.06 SWR on analyzer.
> CW Key down, 100W, I get 1.2 on external SWR meter and 1 bar on K3S SWR
> meter.
> With FT8 I'm OK for 1 or 2 transmits and then I get infinity on external SWR
> meter and full scale on K3S SWR meter, but full power out.
> If I switch to a dummy load, I get zero power out (fold back?)
> If I operate FT8 at 8 watts with the beam, I get 1.2 on external SWR meter
> and 1 bar on K3S SWR meter and 8 watts out.
> Going back to CW full power seems to perform a reset.  Everything still fine
> in CW, but now FT8 is OK for 1 or 2 transmits and then high SWR returns.
>
> Any advice?
> A spur/oscillation in the KPA3A?
> A relay stuck/not switching?
>
> My TenTec Eagle is carrying the load for me during these 6M openings.
> (46 states worked in last few weeks)
>
>
> ___________
> 73,
> Jim - N4ST
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to w0mu at w0mu.com