[Elecraft] [POSSIBLE SPAM] Re: KPA500 / 270V ERR

[Dr. William J. Schmidt]

If you check the schematics, the 270V is made/comes from the power supply...
BUT the 60V enable relay (feeds the voltage divider and read on the front
panel) is on the PA board... 

-----Original Message-----
From: elecraft-bounces at mailman.qth.net <elecraft-bounces at mailman.qth.net> On
Behalf Of Andy Durbin
Sent: Sunday, July 17, 2022 7:35 PM
To: elecraft at mailman.qth.net
Subject: [POSSIBLE SPAM] Re: [Elecraft] KPA500 / 270V ERR

"I think it may actually be the other way around... The 60V relay does not
close if 270V is missing?"

Assume 60 V Enable relay K1 is not closed.  How would 270 V be produced?
The secondary winding of T1 is open circuit.

Andy, k3wyc
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to bill at wjschmidt.com