[Elecraft] Wanted: KPA100 Amplifier for K2

[Fred Jensen]

Take out the screws, remove the KPA100 top disconnecting RF and 12V 
molex cables, find LP top, connect RF and 12V molex cables from LP top, 
install screws.  Required tools: small screwdriver. Cautions: see below. 
Time: 10 min.

<below> Make sure you get the two molex cables into the right connectors 
on the main board!!!  Ask me how I know 😉

73,

Fred ["Skip"] K6DGW
Sparks NV DM09dn
Washoe County

Andrew Moore wrote on 7/9/2022 10:26 AM:
> Hi Bill & list -
>
> I bought a K2 from someone on the list and it came with the KPA100, which I
> tried out (works fine) but am not likely to use. If I can figure out how to
> uninstall it, it will be available. I'll just need to go through the manual
> and make sure I can reinstall components (if any) that might have been
> removed during the install.
>
> Has anyone on the list gone through this exercise and can tell me what's
> involved?
>
> Thanks & 73,
> -Andrew NV1B
>



-- 
This email has been checked for viruses by AVG.
https://www.avg.com