[Elecraft] KPA1500 wattmeter adjustment

[Dick Dievendorff]

If you turn in the Tech Mode menu item, there is a WMTR ADJUST menu item that might be easier to use than the command tester commands. 

73 de Dick, K6KR

> On Feb 5, 2022, at 10:33, N2TK via Elecraft <elecraft at mailman.qth.net> wrote:
> 
> If I measure the power out on my K3 (set to 100W), P3, LP-100 and KPA1500 (power on but in standby), they all read quite close on 10-160M into a dummy load. On 6M the P3 reads 16% higher than the other three. If I use 20W drive from the K3 and put the KPA1500 in operate mode, the P3 and LP-100 read quite close into a dummy load. But the KPA1500 reads about 6-11% higher on 6-160M.The readings are close enough not to be concerned. Looking at the KPA1500 manual there are commands to adjust the wattmeter readouts by band.  I tried commands in the KPA1500 utility Command Tester (^RV;) as an example, but nothing happened. Checked the Port tab to make sure the utility is connected to the amp.What am I doing wrong? Can you do what I am trying tp do from the Command Tester.TnxN2TK, Tony
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dick at elecraft.com