[Elecraft] K4: "R" in display

[Peter Eijlander (PA0PJE)]

Yes,Ludwig, it works OK, now!

I use Thunderbird as well and have set it to plain text from the start 
using it. I am against any markup. It has been asked many times to 
change that on the qth.net mailman and many times was responded with 
"no" by the maintainers. Users that send both should know that markup is 
removed and only the plain text part is distributed.
Data is money so keep the data as small as possible.

73,
Peter

Op 09-09-2021 om 13:46 schreef Ludwig Hechler:
> Oops, I'm sorry!
> 
> I configured my Thunderbird and hope it works now.
> Here is my text again.
> 
> Hi folks,
> 
> finally my K4 has arrived in DL. And here is my first question.
> 
> What is the "R" in the display below the filter icon of the SUB RX?
> The upper part of the "R" is white, the lower part is yellow. Some
> illustrations in the Introduction to the Elecraft K4, e.g. the page
> RECEIVER CONTROLS AND ICONS, show the icon K4D at this
> position. Mine is a basic K4 without D.
> 
> thanks & 73,
> Lui, DL6FBR