[Elecraft] Elecraft K-Pod manual updated -- now covers use with the K4

[Jim McDonald]

Does the selection of encoder rates only apply to the K4?

73,  Jim N7US

-----Original Message-----
From: elecraft-bounces at mailman.qth.net <elecraft-bounces at mailman.qth.net> On Behalf Of Wayne Burdick
Sent: Thursday, October 28, 2021 10:49
To: Elecraft Reflector <elecraft at mailman.qth.net>
Subject: [Elecraft] Elecraft K-Pod manual updated -- now covers use with the K4

The K-Pod is an accessory control panel that's ideal for use with the K4. It provides 16 switch functions; control of VFO A/VFO B/RIT-XIT offset; and three general purpose open-drain outputs for station control. You can use the K4's macro editor to create command sequences to assign to K-Pod switches.

For further product details, see:

  https://elecraft.com/collections/k-pod-desktop-control-panel

Revision F of the K-Pod owner's manual now provides complete instructions for use with the K4 transceiver. The manual can be found here:

  https://ftp.elecraft.com/K-Pod/Manuals%20Downloads/E740285%20KPOD%20Owner's%20Manual%20Rev%20F.pdf

K-Pod firmware was also recently updated: Rev. 1.12 lets you configure the K-Pod's encoder to have the same resolution as those on the K4 (up to 400 counts per turn). 

73,
Wayne
N6KR