[Elecraft] Help getting WSJTx audio out thru K3

[Don Wilhelm]

Bob,

Go to my webpage www.w3fpr.com and read the articular about setting the 
transmit audio levels.
There are up to 3 sound level controls involved, 2 in the computer and 
one in the K3.

If you are using the MIC input, there are 2 levels - high output mics 
and low output mics.  Your audio soundcard should be able to use the 
high output setting, but if it was reset to the low output mic setting, 
that could explain your problem.

Strive for 4 bars solid on the ALC bargraph with the 5th bar flashing.

73,
Don W3FPR

On 10/15/2021 3:43 PM, Bob KD7YZ wrote:
> Hello K3 List
>
> Just got my K3 back from Elecraft.
> Updates past K3s
> KSYN33A Upgrade installed.
>
> Now, I haven't had the K3 for about 3 months. But when I went to use WSJTx, FT8, as well as FLDigi, although the rig keys; goes on correct frequency, no audio drive appears at the rig .... nor at the Sound Control panel "Level" of the audio codec.
>
> I can decode the FT8 alright.
>   And if I redirect the audio output of FLDigi to sys-speakers, I hear the audio, when trhe rig also keys.
>
> Where is an internal "Config" setting that got reset during the serious re-vamping of my K3?
>
> thanks
>