[Elecraft] Scanning With a K3s

[Dave]

A > B on the front panel will transfer from A to B.

73, and thanks,
Dave (NK7Z)
https://www.nk7z.net
ARRL Volunteer Examiner
ARRL Technical Specialist, RFI
ARRL Asst. Director, NW Division, Technical Resources

On 10/12/21 6:01 AM, Richard wrote:
> The manual says:
> 
> "Set VFO A to the starting frequency, and VFO B to the ending frequency."
> 
> This becomes tedious if I want to scan the entire 10-meter SSB segment; cranking VFO B to 29.700 takes forever.
> 
> Is there a way I can use FREQ ENT to put 29.700 in VFO A, then transfer or copy that to VFO B, then put 28.300 in VFO A? Can I use FREQ ENT to do the latter?
> 
> Thanks.
> 
> Richard Kunc – W4KBX
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dave at nk7z.net
>