[Elecraft] KX2 Starts Off with Low Output on 10M

[Tim Tucker]

Mine does that too.  What works for me is to tweak the mic gain up and then
back to the same level and it starts working normally.  Seems to me like
there is a firmware bug with the radio that hasn't been figured out and
addressed yet.

Tim

On Sun, Feb 28, 2021 at 6:08 PM Brian Hunt <huntinhmb at coastside.net> wrote:

> Nate,
> A couple more questions:
>
> Does the KX2 do the same thing on CW?
>
> Did Elecraft say anything about doing a TX gain calibration?  This can be
> done with the KX2 utility although I haven’t done it on mine, just on my
> K3. It sets the per-band gain coefficients  Be sure to save the current
> CONFIG file so you can restore it if needed. You will need a good dummy
> load an a stable power source. The procedure is on p. 38 of the Rev A5
> Manual.
>
> Good luck,
> 73,
> Brian, K0DTJ
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to ae6lx at worldwidedx.com



-- 
Owner, worldwidedx.com
AE6LX, Amateur Radio