[Elecraft] Pin 1 and Grounding Post on the K3s

[John Oppenheimer]

Hi Peder,

K3s grounding post is also one of the board ground plane to enclosure
connections. See Assembly manual, Page 68, Figure 97.

John KN5L

On 6/23/21 9:58 PM, Peder Kittelson wrote:
> I have been following the Pin 1 grounding discussions with interest.  I
> have one of the last Elecraft K3s Transceivers built at the factory and
> love using it.
> 
> I wonder if the grounding post on the back of the K3s attaches directly to
> the case or runs to the motherboard ground?
> 
> I currently have the grounding post attached to an RF grounding strap
> running as a single point ground between all my devices to keep from
> voltage differences.
> 
> Should I be concerned?
> 
> 73 to all,
> 
> Peder, W7RPK