[Elecraft] KAT500 Tuner antenna selection stuck in #2 position

[Lance HP]

I found my issue.....operator error.
I didn't realize that the band selection was only 160m. I didn't try 
changing the antenna config when 160m was selected since I don't operate 
on 160m yet.

I don't remember how that got changed. Anyway...selected all bands AND 
selected enabled for all antennas and it works fine.

Sorry about that!
I am still loving this autotuner. Currently tuning a doublet, but will 
be tuning a longer wire soon (most likely a loop).

Lance
KK4DX

------ Original Message ------
From: "Andy Durbin" <a.durbin at msn.com>
To: "Lance HP" <lstronk at optonline.net>
Sent: 6/14/2021 11:03:49 AM
Subject: Re: Re[4]: [Elecraft] KAT500 Tuner antenna selection stuck in 
#2 position

>With the configuration shown all antennas should have been selectable 
>on 160 m.  I assume your did not make a screen shot with band selected 
>to the band that exhibited the problem.
>
>Having the same enabled antennas on ALL bands may be appropriate for 
>your station but  some of my antennas are single band and must only be 
>enabled on one band.
>
>Anyway, sound like it was doing what you had told it to do but your 
>email may be rejected by the "list" because of the embedded image.  
>Perhaps post there to say you found the problem?
>
>73,
>Andy, k3wyc
>
>
>>