[Elecraft] KAT500 Tuner antenna selection stuck in #2 position

[Phil Hystad]

I have had a similar problem and in my case I was not looking at the right spot
for adjusting the antennas.

There are two different spots when using the KAT500 utility.  The Operate menu selection and then also the Configuration\Antennas selection. 

In my case, the Operate page would not let me change the antenna (nor the KAT500) because the configuration of antennas was not set up properly.  I have no idea how those got changed since they had been OK before but I reconfigured the antenna selection options and saved the configuration and everything worked correctly after that.

73, phil, K7PEH


> On Jun 13, 2021, at 8:15 AM, kk4dx <lstronk at optonline.net> wrote:
> 
> Anyone have this happen to them?
> I cannot change the antenna selector via the front panel of the KAT500 or
> the utility software. The utility software is working as I can remotely
> cycle through the modes, but the antenna selector is stuck. All antenna
> positions are checked (enabled) in the utility software and when I advance
> to another position, the software moves the selection back to #2.
> 
> 
> 
> --
> Sent from: http://elecraft.365791.n2.nabble.com/
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to phystad at mac.com