[Elecraft] Gurus

[Dave B]

Should be easy to gauge...

How "clean" (or otherwise) is his signal on your RX, with no antenna 
connected, and all the RX attenuation switched in.

Perhaps also fit a well screened dummy load to the rig's antenna port(s)

Also disconnecting just about everything else except the power (and put 
some ferrite on that!)

All that should greatly reduce the level of his signal that your radio 
"see's" to manageable proportions.

Even turn the RF gain down too if needed.

If he's not splattering as much or at all, then it is likley your RX is 
being overloaded.

If it sounds just as bad, and splattering just as wide, then likely it's 
his end.

Regards to All.

Dave G8KBV



On 10/06/2021 05:01, elecraft-request at mailman.qth.net wrote:
> I can't tell if it's a bad radio on his end or just front end
> overload on my end.

-- 
Created on and sent from a Unix like PC running and using free and open source software: