[Elecraft] K1 filter board relays

[d_zank]

HiSo I am trying to get my old K1  back up and running.   Two, 2 band modules, 80/40 and 20/15 and b1 on each was dead.   No oscillator signal at pin 4 on P1, b2 fine. Replaced X1 crystals on both boards because the boards had been in storage and bounced around. No change until I tapped on K1 relay then b1 started working on 80/40 but b2 stopped.  Now I am suspecting relay problems although ohm meter checks look ok. Just wondering if anyone has similar experience with the relays on the filter board.S/N 02134. Thanks Don AA9WP Sent from my Galaxy