[Elecraft] K2 Only 30-metre Band Works

[VA1CQ]

Hi Jerry,

Your advice is good. I never did get that soldering iron technique to 
work for stripping the toroid wire. I used the fine sandpaper supplied 
with the K2 to manually bare each wire end. After I soldered, for each 
connection, I checked using an ohm meter for continuity between solder 
pads at each end of the toroid wire on the board (not between the 
wires). I figured this should confirm that the toroid wire was in fact 
connected to its solder pad.

73,
Murray VA1CQ


-- 
This email has been checked for viruses by AVG.
https://www.avg.com