[Elecraft] 10 mhz problem ...while running tx gain

[Bob McGraw]

What is the length of the coax jumper between the radio and dummy 
load?    Also, if an antenna analyzer is available, run a sweep on the 
load, with the meter in place  and observe the results.

73

Bob, K4TAX


Message: 11
Date: Thu, 28 Jan 2021 10:50:35 -0500
From: Bill Steffey NY9H<ny9h at arrl.net>
To: Elecraft List<elecraft at mailman.qth.net>
Subject: [Elecraft] 10 mhz problem ...while running tx gain
Message-ID:<e3af52a3-6721-d84f-c9c9-2b13d895ff77 at arrl.net>
Content-Type: text/plain; charset=utf-8; format=flowed

i am very rarely on 10 mHz,


while running tx gain set , the calibration fails at 10mhz due to

  ? SWR 3.3-1 TOO HIGH FOR CALIBRATION.


checking other bands..160- 6 all read low swr


lp-100 & WATERS swr/load? read low swr ..... ? hi swr? just reads on
radio & faults the tx gain procedure ????


ideas ???


-- 
This email has been checked for viruses by AVG.
https://www.avg.com