[Elecraft] 10 mhz problem ...while running tx gain

[AB1DD]

Bill,

What radio? Is the RF gain cal. OK (assuming a K3)?

What is the SWR on the radio into the dummy load without trying to do 
the calibration, I.E. direct? Don't know for sure that is what you meant.

You can try to do it manually, just on the 10 Mhz band. Then run the 
whole thing to see if it works, if you want.

Carl
AB1DD

Resistance is futile.
(don't know about reactance, though)


On 1/28/2021 10:50 AM, Bill Steffey NY9H wrote:
> i am very rarely on 10 mHz,
>
>
> while running tx gain set , the calibration fails at 10mhz due to
>
>   SWR 3.3-1 TOO HIGH FOR CALIBRATION.
>
>
> checking other bands..160- 6 all read low swr
>
>
> lp-100 & WATERS swr/load  read low swr .....   hi swr  just reads on 
> radio & faults the tx gain procedure ????
>
>
> ideas ???
>
>
> bill
>
>