[Elecraft] P3 Issue

[gt-i at gmx.net]

You could first check if you get stable connection using the
PX3-utility. If that does not work, it could be an unstable power supply
issue (0,5A ~12V required).

Otherwise I suppose there is a loose connection inside of the P3. You
could check the cable from the main board to the display. The manual has
a section about replacing the display with useful pictures (fig 25&26).

73 Gernot DF5RF

Am 11.01.2021 um 23:46 schrieb Ken Widelitz:
> P3 stopped working. When turned on, the entire screen flashes from red to
> green to blue to blank to grey to checkerboard to grey and then cycles
> through those screens again, etc. I have done a reinitialization by holding
> down the Label key while turning on the power. Nothing changes.
>
> 73, Ken, K6LA / VY2TT
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to gt-i at gmx.net