[Elecraft] KX2 Starts Off with Low Output on 10M

[Brian Hunt]

Nate,
A couple more questions:

Does the KX2 do the same thing on CW?

Did Elecraft say anything about doing a TX gain calibration?  This can be done with the KX2 utility although I haven’t done it on mine, just on my K3. It sets the per-band gain coefficients  Be sure to save the current CONFIG file so you can restore it if needed. You will need a good dummy load an a stable power source. The procedure is on p. 38 of the Rev A5 Manual. 

Good luck,
73,
Brian, K0DTJ