[Elecraft] TX Gain Calibration Fails on 6 meters

[David J. Schmocker]

Hello, K3S. S/N 11532 K3 Utility running on Mac OS 10.14.6 Mojave

I found that running Transmitter Gain utility requires these settings within
K3S Config menu to enable test to pass (with good 50 Ohm load on both ANT1
and XVTR-Out ports): 

Transmitter Gain tests: 
5W test.  requires Config - XVTR -  OFF
50W test requires Config - XVTR -  OFF
mW test requires Config - XVTR - ON.  

I suppose this makes sense (turn the transporter on for the mW test which is
used to drive the Transverter). 

73,
Dave KJ9I




--
Sent from: http://elecraft.365791.n2.nabble.com/