[Elecraft] K2

[Don Wilhelm]

Snowy,

Make sure the switch on the Control Board is in the INT position.
If using a battery, it may have a low voltage - it must be higher than 
10.5 volts.

73,
Don W3FPR

On 12/20/2021 11:19 AM, snowy howell via Elecraft wrote:
> Hi All
> Update on the K2 and its problems or now lack of them.
> Finished setting up the filters and other than getting ‘low Batt’ indication now and again all appears to be well.
> Fitted the KAF2 and set up the clock, that taxed my grey cell but managed it in the end.
> Just need to give it an on air test and that’s it, sorted.
> Just want to thank Dave and Don for their help in getting me to this point.
>   Thanks very much
>
> 73
>
> Snowy G0HZE