[Elecraft] ID a small board

[Joe Subich, W4TV]

> In a small zip bag was board with a 4 pin connector on each end. On
> the back it is printed "Remove to instal KPA3".
Probably a "KPA Jumper Block" ... it is installed for low power
operation if the KPA3 is removed.

73,

    ... Joe, W4TV


On 2021-12-05 4:36 PM, Neil Foster wrote:
> Recently I purchased a KPOD from a local SK's estate. In a small zip bag
> was board with a 4 pin connector on each end. On the back it is printed
> "Remove to instal KPA3". In searching the parts list it says the KPA3 is a
> 12V Sense Mod 1N4148. On the front next to the connectors are marked J67a
> and J67B and the component is marked C241.
> I am trying to figure out what this module is and how it was used. It came
> with the KPod but I am not sure it has any bearing. My radio is a K3s
> Many thanks    Neil   N4FN