[Elecraft] Rx-In/Out used for exteranl SDR Device?

[Bob KD7YZ]

Hello Richard Ferch:

Saturday, December 4, 2021, 8:38:26 PM, you chiseled out:

> To use the RxAnt In/Out BNC connectors in the KXV3, you need to select the

> RX Ant from the front panel RX Ant switch. 

I have a Mini-Circuits splitter.
It comes off the Rx-Out of the K3s. The other two of the splitter go to SDRC and K3s Rx-In

first off, it seems the SDR device is only getting decent output, vis-a-vis Band, from whatever Band I have the K3 set to.

Secondly, it seems that the K3 then is about 6 S-Units down on the same band than it was without the "Rx Ant" being pushed on the K3.


--

Best regards,

Bob KD7YZ EM88LL