[Elecraft] K3 Auto ATU Problem

[Rick Bates, NK7I]

The KAT3 performs well at 10 watts, lower output levels may not get 
consistent results.

Ditto the KAT500 and KPA1500 tuners.

73,
Rick NK7I


On 12/4/2021 8:58 AM, Dave wrote:
> Hi Tom,
>
> In your initial post, you failed to state the power level of your 
> failed autotune event.
>
> Hence why my question did not ask what the tuning level needed for the 
> K3 to trigger was, but at what power level you were performing your 
> failed autotuning event at.
>
> My thinking was that you might be below the auto tune trigger threshold.
>
> 73, and thanks,
> Dave (NK7Z)
> https://www.nk7z.net
> ARRL Volunteer Examiner
> ARRL Technical Specialist, RFI
> ARRL Asst. Director, NW Division, Technical Resources
>
> On 12/4/21 07:56, Tom Boucher wrote:
>> Dave (NK7Z),
>>
>> The K3 performs its auto-tune sequence at a power output of 5 watts I
>> believe.
>>
>> 73,
>> Tom G3OLB
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to dave at nk7z.net
>>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rick.nk7i at gmail.com